Operation Manual

7
DL451 Modular I/O
Operator Manual
Chapter 4: Getting Started
This section shows you how to connect up, switch on, set up and configure the DL451
Modular I/O unit.
Connecting up
Connect up the following, as appropriate, to the rear panel of your DL451 Modular I/O
unit:
• Inputs/outputs - connect up modules in slots A, B and C. These can be any
combination of modules DL441, DL442 and DL452; see page 5 in Chapter 3 ”Rear
Panel”.
• AES50 - connect the AES50 audio X and Y sockets to the appropriate AES50
audio sockets on the X and Y routers.
• Ethernet - connect the Ethernet control X and Y sockets to the appropriate
Ethernet control sockets on the X and Y routers.
• MIDI - connect the three MIDI 5-pin DIN connectors, if required.
• GPIO - connect the 25-way D-type connectors, if required.
• USB - connect a laptop/PC, if required.
• Mains power supply - insert the IEC connector of the mains cable into the rear of
the unit and then plug it into the mains power outlet.
Switching the unit on/off
After you have connected up your DL451 Modular I/O, it is ready to be switched on. To
do this, switch on the mains on/off switch on the rear of the unit.
To switch off the DL451 Modular I/O unit, press the mains on/off switch.