Operation Manual

14 Chapter 5: Programming Mode
DL451 Modular I/O
Operator Manual
Menus
The five menus in programming mode are as follows:
• 1 AES clock — for selecting the method for synchronising the AES50 (see “1 AES
clock menu” below).
• 2 Set ID — for setting up the DL451 Modular I/O’s network unit ID (see “2 Set ID
menu” below).
• 3 CBMA Version — for viewing the unit’s CBMA version number.
• 4 Software Vers. — for viewing the unit’s software version number.
• 5 Digital boards — for setting up the digital I/O board(s) of the DL451 Modular I/O
unit, if fitted (see “5 Digital boards menu” on page 15).
1 AES clock menu
This menu lets you set up the clock source of the DL451 Modular I/O, as internal or
external, for AES synchronisation.
>> To set up the unit’s clock source
1 In programming mode, select menu 1 (see “To select a
menu” on page 9). The current clock source is shown
on the bottom line of the display, for example,
“Internal clock”.
2 Use the down arrow to select the AES clock source you
want, for example, “External clock”. The bottom line
will flash to show that this option is not currently
selected.
3 Press SELECT. The bottom line will stop flashing to show that this option has
been selected.
4 Press MENU.
2 Set ID menu
This menu lets you set up the network ID of the DL451 Modular I/O, which can be any
number from 1 to 10.
>> To set up the ID of the unit
1 In programming mode, select menu 2 (see “To select a
menu” on page 9). The current ID is shown on the
bottom line of the display, for example, “1”.
2 Use the down arrow to go to the ID you want, for
example, “7”. The ID will flash to indicate that it is not
currently selected.
If you don’t want to change the ID number, go to the “Unchanged” option, which
is between “10” and “1”.