Specifications

0
0
+10
+10
level level
insert insert
direct inputs
MUTE
SOLO
PRE
MUTE
SOLO
PRE
+21+
+18+
+15+
+12+
+9+
+6+
+3+
0
-3-
-6-
-9-
-12-
-15-
-18-
-21-
-24-
-27-
-30-
-33-
-36-
lr
The METERS monitor the peak signal
levels of the sub group outputs
(post fader).
The DIRECT input controls give
continuous adjustment of the direct input
levels from + 10dB to off. The direct
signals are summed into the sub group
signals and can be used as effects returns
etc. or for console bus linking.
The direct PRE switches move the point
at which the direct signals are summed
into the sub groups. The default is post
insert but when the PRE switches are
active the signals are summed at the sub
group mix busses.
The direct MUTE switches mute the sub
group direct inputs at all points.
The direct SOLO switches send direct
inputs to the PFL mono and AFL the
stereo busses (AFL is selected as stereo
or mono depending on the group SPLIT
switch settings). If a SOLO switch is
pressed for a short time it will latch on or
off, but, if it is held on for more than 1
second the latching is disabled and when
the switch is released the solo will turn
off. As a default the solo system is auto
cancelling so each new solo cancels the
last. This function is time dependant
which allows several solos to be active as
long as they are switched on at
approximately the same time, i.e. to solo
both sides of a stereo mix press both solo
switches at the same time. Alternatively
the SOLO ADD MODE switch on the
MONITOR module can be used to defeat
the auto cancelling and allow multiple
channel monitoring. In this mode input
channel solos have priority over all other
solos and will temporarily override them.
16