User's Manual

64 Chapter 7: Output Section

VeniceF

Operator Manual

Monitors

There is an output connector and insert connector on the rear panel for both monitor

bus outputs.

Two monitor inserts and two monitor outputs on rear panel

FireWire output is available for the monitors by the overriding the relevant dual stereo

input channel. For more information, see “FireWire” on page 58.

There are two discrete monitor sections on the control surface, which can be monitored

on the first two group meters.

Monitor channels (1 and 2)

Item Description

1 Meter LEDs These LEDs comprise the monitor meter when the monitor

switch (immediately below) is on. This meter monitors the signal level of

the monitor bus. Range is from -12dBu to +18dBu (3dBu steps from

-12dBu to 0dBu, and 6dBu steps from 0dBu to +18dBu).

2 Monitor switch This is the meter changeover switch (from group).

3 pre switch This is the bus master pre-fader switch.

4 monitor 1 control knob This output level control gives continuous

adjustment of the monitor output signal from +10dB to

4 (infinity/off).