Specifications

Dual stereo delay B-11
Midas Digital Consoles
Addendum B
selected on the delay control and the global tempo is 120 bpm the delay value
shown will be 0.75 x 60/120 bpm = 375 ms.
• With global tap disabled the display shows the actual delay time set on the unit.
• Up/down buttons adjust delay units by 1 millisecond increments.
If the global tap option is enabled the delay time rotaries will change from seconds
(milliseconds) to musical note durations as they do with the current effects units.
However, the seven-segment LED display will continue to follow the display mode
selected. Also, if the global tap option is enabled the tap button on the unit will not
affect the global tempo and should be greyed out.
Item Element(s) Function
1 On/off switch Switches the delay effect in or out.
2 delay time
controls
The control knob adjusts the delay time in the range
0 seconds to 2 seconds in 5 milliseconds increments.
In global tap mode, adjusts the note intervals.
Switching the X2 switch changes the delay time scale
to 0 seconds to 4 seconds in 10 millisecond intervals.
3 tap button Use this button to tap in the delay time or tempo
manually.
4 up and down
buttons
Increases/decreases the delay time by 1 millisecond
0.1 bpm
5 Display Shows current delay time and selected unit.
6 feedback control
knob
Adjusts the delay feedback loop gain in the range 0 to
100%.
7 lf cut controls This low frequency control knob applies a 6dB/Oct
high pass filter to the delay and optionally feedback
signal (by switching on the post fb switch below).
The default is post-delay and pre-feedback. Range is
from 10Hz to 500Hz.
8 hf cut controls This high frequency control knob applies a 6dB/Oct
low pass filter to the delay and optionally feedback
signal (by switching on the post fb switch below).
The default is post-delay and pre-feedback. Range is
from 200Hz to 20kHz.
9 mix control knob Adjusts the dry/wet signal ratio.
10 Meters Input and output meters.
123 5 6789
10
4