Operation Manual

107
PRO1 Live Audio System
Operator Manual
Chapter 14: Monitors And
Communications
This chapter describes the monitoring and communications functions of the PRO1.
Monitors (A and B)
To match the two-bus solo system there are two monitor outputs, A and B, which
control their respective output levels. These are controlled from the monitor section on
the master bay (see Figure 8 “Monitor A and B strips” on page 108). Each monitor
output has:
• The ability to monitor mono and stereo outputs, and an external input.
• An external talkback input.
• A local monitor output.
• A headphone output.
•Delay compensation.
• Control of the solo buses.
Although the capabilities of both monitors are the same, monitor A is the primary
output. They both have a fader control, and there are four balanced XLR outputs on the
rear panel).
The monitor output controls do not have support from the screens and are not affected
by automation.
The monitor a and monitor b meters monitor the peak signal levels of stereo left and
right for both monitor paths. The metering capabilities of both monitors is the same.
>> To switch control of headphones to fader
Press C/O.