Operation Manual

180 Chapter 21: Scope (Automation)
PRO2 Live Audio System
Owner’s Manual
>> To select a single parameter section
1 Click SINGLE.
2 Click the desired parameter section.
In some cases more than one parameter section may be selected. This may occur if:
• The parameter section belongs to a channel that is stereo linked. The equivalent
parameter section of the other paired channel will also be selected.
• Other channels are patched to the same source as the channel in which you are
making your selection. This only applies to the All and Mic Amp parameter
sections.
>> To select a parameter section in all channels of a single type
1 Click BY CHANNEL TYPE.
2 Click the desired parameter
section in any channel of the
desired type. For example, click
the routing parameter section in
any of the input channels. The
routing parameter section on all
input channels will be selected (as
shown right).
>> To select all of the parameters of a single channel
1 Click INDV. CHANNEL.
2 Click any parameter section in the desired channel. For example,
click the All parameter of input channel 5; all the parameter sections
in channel 5 are selected (as shown right).
If the channel is stereo linked, all of the parameter sections in its paired
channel will also be selected.