Operation Manual

512 Appendix K: Parameters Copied Through Scenes
PRO2 Live Audio System
Owner’s Manual
Inputs (input channels)
This section shows you which parameters for each of the 96 input channels are affected
by copy through scenes.
Config sections
The following diagram shows the parameters of the input channel configuration detail
area copied through scenes.
* Applies to primary and tape inputs.
Item Control Parameter
1 gain trim control
knob
Digital trim level
2
Ø switch
Phase on/off switch
3 level control knob Direct output level
4 MODE switch Direct output tap-off point: “Post-fade and mute”,
“Pre-mute, pre-processing” and
“Pre-mute, post-processing”
5 stage box control
knob*
Remote amplifier level
6 30Hz switch* 30Hz filter on/off
7 delay control knob Delay time
8 C/O switch
Order of processing: Dyn.
JIns.JEQ or
EQ
JIns.JDyn.
9 48V switch* 48V phantom voltage on/off
10 MUTE switch Direct output mute on/off
11 SOLO B/[B] switch Direct output solo B on/off
6
1
9
9
1
9
8
8
1
2
5
2
2
10
11
4
5
7
3