user manual

46 Chapter 8: Basic Operation

XL8 Control Centre

Quick Reference Guide

3 In the effect’s (empty) window, click Change Device

Type.

4 In the Change Device Type window, choose the device type.

For example, “Phaser”.

5 Click OK.

6 Change the parameters of the new effect device as

necessary. For example, adjust control knobs, press

buttons etc. You can even change the effect’s name

by editing its name field (upper-left corner of effect

window). You can do this via the GUI or from the

I zone using the output bay GUI (see Figure 2 “Main

areas of control surface” on page 7).

7 Click CLOSE to exit. The new effect will appear in the

effects rack.

You can now patch the new effect, which will be on the

Effects tabs of both the From and To sections of the

Patching screen. For information on how to patch, see

Chapter 5 "Patching" on page 23.

Simple routing to master stereo outputs

The following shows you how to obtain audio.

>> To obtain audio

1 Make sure nothing is muted and the master

faders are up.

2 In the masters section of an input fast strip

(or the output channel strip), press the ST

(stereo) button. You should have audio.