Service manual

4
ATTENTION!
CABLES
This product should only be used with high quality, screened twisted pair audio cables, terminated with
metal bodied 3-pin XLR connectors. The cable shield should be connected to pin 1. Any other cable
type or configuration for the audio signals may result in degraded performance due to electromagnetic
interference.
ELECTRIC FIELDS
Should this product be used in an electromagnetic field that is amplitude modulated by an audio
frequency signal (20Hz to 20kHz), the signla to noise ratio may be degraded. Degradation of up to
60dB at a frequency corresponding to the modulation signal may be experienced under extreme
conditions (3V/m,90% modulation).
No permanent damage or degradation of performance will be caused by these conditions.