Use and Care Manual

 Page 13 
Operating
Instructions
• Make sure the hose is secure so there are no leaks.
• Direct the hose toward the drain, making sure that
there are no kinks that will stop the warter flowing.
• Place the end of the hose into the drain.
• Select the desired humidity setting and fan speed
on the unit for pump draining to start.
NOTE
The pump may generate a loud noise when it starts to
work for 3 ~ 5 minutes.
NOTE
The pump operation light blinks when a failure occurs.
Please turn off the unit and disconnect the power cord.
Check the following things:
• Cleaning the pump filter:
- Remove the bucket from the unit, take down the
pump and clean the pump filter (See Fig. 12).
• Check if the drain hose is clean and free of debris.
• Empty the water of the bucket.
• Check the hose connection and the bucket
for proper fitting. If the error persists, contact
Customer Service.
Fig. 12
NOTE
Do not use this operation when the outdoor
temperature is equal to or less than 0°C (32°F),
otherwise water may become ice causing the water
house to be blocked and the unit to stop operating.
Make sure to empty the bucket at least once a week
a week when using the pump draining feature. When
the pump draining feature is not being used, remove
the pump drain hose from the outlet.
Filter of the pump