Instructions / Assembly

 Page 11 
Operating
Instructions
NOTE
Make sure the hose is secure so there are no leaks.
Direct the hose toward the drain, making sure that
there are no kinks that will stop the warter flowing.
Place the end of the hose into the drain and make
sure the end of the hose is down to let the water flow
smoothly. (See Figs with ). Do never let it up. (See
Figs with
X
). When the continuous drain hose is not
used, ensure that the corresponding drain plug and
knob are installed firmly to prevent leakage.
NOTE
Be sure to reinstall the bottom drain plug firmly to
prevent leakage before using the unit.
• During heating pump mode, remove the lower drain
plug from the back of the unit, install the drain
connector (5/8” universal female mender) with 3/4”
hose (locally purchased). For the models without drain
connector, just attach the drain hose to the hole. Place
the open end of the Hose adaptor directly over the
drain area in your basement floor.
¥
Drain hose
adaptor
Continuous
drain hose
Remove
the lower
drain plug
¥
Delivery lift <1.8m
Drain
hose
adaptor
Drain
hose
adaptor
X
• When the water level of the bottom tray reaches
a predetermined level, the unit beeps 8 times,
the digital display area shows “P1”. At this time
the air conditioning/dehumidification process will
immediately stop. However, the fan motor will
continue to operate (this is normal). Carefully move
the unit to a drain location, remove the bottom drain
plug and let the water drain away. Reinstall the bottom
drain plug and restart the machine until the “P1”
symbol disappears. If the error repeats, call for service.