Use and Care Manual

Install Vent System
Install vent through the vent opening in upper cabinet
2. INSTALL RANGE HOOD (Ducted
version)
Detach the 3¼” x 10” (8.3 x 25.4 cm) rectangular
1.
vent
damper from the package.
Vent Damper Installation
Install 3¼” x
10” (8.3 x 25.4 cm) vent damper.
Attach to range hood using the indicated screws
provided in hardware kit.
If a vent damper is installed with a wall cap with
damper, check that they do not interfere with each
other. Remove the vent damper flap if they interfere.
•
v
ent knockout A.
Power Supply Cable Installation
For direct wire installations, run the home power
supply cable according to the National Electric Code
or CSA standards and local codes and ordinances.
1.
F
or roof installations, remove the top rectangular
•
For wall installations, remove the
NOTE
Remove the screws from the
terminal box cover.
Remove terminal box cover
and set aside.
2.
A
B
A. 3¼” x 10” (8.3 x 25.4 cm) rectangular vent damper
A
Install the 3¼” x 10” (8.3 x
25.4 cm) rectangular vent
transition
A. 3¼” x 10” (8.3 x 25.4 cm)
B
C
A
B
Do not reconnect power until the installation
is complete.
Before starting the installation, remove the
vent grill and grease filters.
rear rectangular vent knockout B.
C
B
A. Top rectangular knockout
B. Rear rectangular knockout
when use A or B air
outlet, need Insert c baffle
C. Long baffle
A. Terminal box cover
B. Screw
D
Use D air outlet,retention A and B materials
•
3. Internal recycle air outlet
•
Wall Venting
PREPARE THE LOCATION(100CFM Ducted version)
11