Use and Care Manual

Install Vent System
Install vent through the vent opening in upper cabinet
2. INSTALL RANGE HOOD (Ducted
version)
1.
Detach
the Ø7.08” (Ø 18cm) rectangular vent damper
from the package.
Vent Damper Installation
Install 3¼” x
10” (8.3 x 25.4 cm) vent damper.
Attach to range hood using the indicated screws
provided in hardware kit.
If a v
ent damper is installed with a wall cap with
damper, check that they do not interfere with each
other. Remove the vent damper flap if they interfere.
•
vent knockout A.
Power Supply Cable Installation
For direct wire installations, run the home power
supply cable according to the National Electric Code
or CSA standards and local codes and ordinances.
1.
For roof installations, remove the top rectangular
•
For wall installations, remove the
NOTE
Remove the screws from the
terminal box cover.
Remove terminal bo x cover
and set aside.
2.
A
B
A.
Ø7.08” (Ø 18cm) rectangular vent damper
A
Install the 3¼” x 10” (8.3 x
25.4 cm) rectangular vent
transition
A. 3¼” x 10” (8.3 x 25.4 cm)
A
B
Do not reconnect power until the installation
is complete.
Before starting the installation, remove the
vent grill and grease filters.
rear rectangular vent knockout B.
C
A. Top rectangular knockout
B. Rear rectangular knockout
C. Long baffle
A. Terminal box cover
B. Screw
D
Use D air outlet,retention A and B materials
•
3. Internal recycle air outlet
•
B
B
PREPARE THE LOCATION(200CFM Ducted version)
12