Operation Manual

Temp: Display the set temperature. Adjust temperature via
and . No display in this area if the unit is on FAN mode.
Transmitting display: The icon will flash once when the signal
is sent by remote controller.
Running mode: Press MODE to display current running mode.
AUTO, COOL, DRY, HEAT and FAN can be selected. (HEAT
function is invalid for cool only type unit.)
ON/FF: Icon is displayed when the remote controller is turned
on, or vice versa.
Lock: The icon will be lightened or off when pressing LOCK.
In locked state, all the buttons are ineffective except button
LOCK.
Time ON/OFF: In the state of time ON, icon ON will be
lightened, which is the same to the state of time OFF.
Setting timer ON and OFF simultaneously, both icons ON
and OFF are displayed.
Time: Display the current set time. Press CLOCK for 5s, icon
indicating hour will flash. Press this button again, icon indicating
minute will flash. And are used to adjust the figure. Setting
or modification is effective only by pressing OK button to make
confirmation.
16
15
14
13
12
AUTO
COOL
DRY
HEAT
FAN
TEMP
SET
CLOCK
SET
HOUR
FAN SPEED
4 5
Temp
ON/OFF
Time ON/OFF
Fan speed
Transmitting display
Lock
Running mode
Economic operation
Chart 2
1
2
4
7
8
3
6
9
INDICATORS AND FUNCTIONS
Time
5
ON OFF
to adjust the figure. Setting or modification is effective only
by pressing OK button to make confirmation.
TIME ON: For time ON setting. Once pressing this button,
the time will increase by 0.5 hour. When the set time exceeds
10 hours, pressing the button will increase the time by 1 hour.
Adjusting the figure to 0.00 will cancel time ON setting.
TIME OFF: For time OFF setting. Once pressing this button,
the time will increase by 0.5 hour. When the set time exceeds
10 hours, pressing the button will increase the time by 1 hour.
Adjust the figure to 0.00 will cancel time ON setting.
11
RESET (inner located): Press this button with a needle of
1mm to cancel the current setting and reset remote controller.
LOCK (inner located): Press this button with a needle of
1mm to lock or unlock the current setting.
OK: Used to confirm the time setting and modification.
COOL/HEAT (inner located): Press this button with a needle
of 1mm to shift mode between COOL only and COOL&HEAT.
During setting, back light will be lightened. Factory default
mode is COOL &HEAT.
ECO: Activate or turn off economic operation mode. It is
suggested to turn on this function when sleeping. (Only
available when remote controller is used with corresponding
unit.)
INDICATORS AND FUNCTIONS
BUTTONS AND THEIR FUNCTIONS