Owner's manual

8
PROGRAMCHANGECAPTURE
PROGRAMCHANGEINC/DEC
PROGRAMCHANGEENTERANDSELECT
ToprogramtheFootswitchControllertocapturetheProgramChangeandBankSelectmessagesitreceiveswhile
thefootswitchisdepressed,senditthefollowingSystemExclusiveprogrammingcommand:
OncetheProgramChangeandBankSelectdatahasbeencaptured,tappingthefootswitchcausestheFootswitch
Controllertoresendthecaptureddata.CaptureddataisretainedevenafterpowerisremovedfromtheFootswitch
Controller.
A singleFootswitchControllermaybeprogrammedtoprovideaProgramChangeINCfunction,ortwoFootswitch
ControllersmaybechainedtogethertoprovideaProgramChangeINC/DECfunction,withoneunitprogrammedas
anincrementunitandtheotherasadecrementunit.
Toprogramtheunitssendthemthefollowingprogrammingcommands:
( isoptional)
( isoptional)
AllbytesmustbeinHexadecimalformat(seehexadecimalconversiontableatend)
=MIDIchannel(seeMIDIchanneltableatend)
isoptional. =minimumvalue, =maximumvalue
ToprogramaFootswitchControllerwiththeProgramChangeINCfunctiononMIDIchannel16,andasecond
FootswitchControllerwiththeProgramChangeDECfunctiononMIDIchannel16,sendthemthefollowingSystem
Exclusiveprogrammingcommands:
INCunit:F0000050040701 F7
DECunit:F0000050040700 F7
ToprogramtheFootswitchControllertoallowakeyboardtobeusedasanumerickeypadtoenterprogramnumbers,
ornotesfromakeyboardtoselectspecificprogramsnumbers,sendtheFootswitchControllerthefollowingSystem
Exclusiveprogrammingcommand:
AllbytesmustbeinHexadecimalformat(seehexadecimalconversiontableatend)
specifiesthemodeofoperationasfollows:
00:Keyboardisusedasanumerickeypadtoentertheprogramnumber(0-127)whilefootswitchis
depressed,withmiddleCrepresenting“0”,toA abovemiddleCrepresenting“9”
>0:Keyboardisusedtoselectaspecificprogramnumber(0-127)whilefootswitchisdepressed,starting
fromnote forprogram#0.Pressingthenotetwiceadds64totheprogramvalue.
(theProgramChangemessageissentonreleaseofthefootswitch)
=MIDIchannel(seeMIDIchanneltableatend)
F0000050040DF7
TheMIDIOutofthedecrementunitmustbeconnectedto
theMIDIInoftheincrementunit.
INCunit:F0000050040701cc(xxyy)F7 xxyy
DECunit:F0000050040700cc(xxyy)F7 xxyy
cc
xxyy xx yy
Example
0F
0F
F00000500414mmccF7
mm
mm
cc