Manual

4
PROGRAMMINGCOMMANDS
DEVICEPARAMETERS
ThefollowingDeviceParametersareineffectregardlessofthefunctionsthatthePedalControllerhasbeen
programmedtoperform.
WhenEchoisON,allincomingMIDImessagesreceivedbythePedalControllerareechoedtoitsMIDIoutput.
WhenEchoisOFF,onlythemessagesgeneratedbythePedalControlleraresenttoitsMIDIoutput.
Specifieshowmuchthepedalmovementdiffersfromalinearresponse.
Specifiesthedirectionofthecurvature.Ifcurvaturedirectionisupward,theoutputvaluewill
risemorequicklyatthebottomofthepedalrangeandmoreslowlyatthetop.Ifcurvaturedirectionisdownward,the
outputvaluewillrisemoreslowlyatthebottomofthepedalrangeandmorequicklyatthetop.
Specifiestheamountofmovementateachendofthepedalforwhichnochangeoccurs.Neutral
RangeTopspecifiestheneutralrangeatthetopofthepedalmovementandNeutralRangeBottomspecifiesthe
neutralrangeatthebottomofthepedalmovement.
TosetthePedalControllerdeviceparameters,senditthefollowingSystemExclusiveprogrammingcommand:
AllbytesmustbeinHexadecimalformat(seehexadecimalconversiontableatend)
=Echo( =00:EchoOFF, =01:EchoON)
=CurvatureAmount( =00:nocurvature, =7F:maximumcurvature)
=CurvatureDirection( =00:downward, =01:upward)
=NeutralRangeBottom(dd=00:Automatic)
=NeutralRangeTop(ee=00:Automatic)
ToprogramthePedalControllertoechoincomingMIDIdatatoitsoutput,respondlinearlytopedalmovement(no
curvature),andautomaticallydeterminethetopandbottompositionofthepedal,senditthefollowingSystem
Exclusiveprogrammingcommand:
F000005016000100000000F7
Echo:
CurvatureAmount:
CurvatureDirection:
NeutralRange:
F00000501600aabbccddeeF7
aa aa aa
bb bb bb
cc cc cc
dd
ee
Example