Instruction Manual

5
CONTROLCHANGEVELOCITYCONTROL
TosetthevelocitytofollowaMIDIControlChangevalue,sendtheVelocityConverterthefollowingSystemExclusive
Programmingcommand:
AllbytesmustbeinHexadecimalformat(seehexadecimalconversiontableatend)
=ControlChange#
=OffsetaddedtoincomingControlChangevalue
=MIDIchannel(seeMIDIchanneltableatend)
TheVelocityConverterwillacceptoneofthesecommands.Iftheoffsetvalue( )addedtotheincomingControl
Changevalueexceeds127,thenoutputvelocitiesareassignedavalueof127.
ToprogramtheVelocityConvertertoassignthevalueofMIDIvolumeonchannel1tovelocities,withanoffsetof20,
set =07(volumeisMIDICC#7), =14(seehexadecimalconversiontableatend),and =00forMIDI
channel1.Asvolumeisincreased,velocitieswillbeincreased.Asvolumeisdecreased,velocitieswillbedecreased.
Theminimumoutputvelocityvaluewillbe20,duetotheoffset.TheabovevaluesresultinthefollowingSystem
Exclusiveprogrammingcommand:
F00000500903 F7
F00000500903aabbccF7
aa
bb
cc
bb
Example
aa bb cc
071400