Owner`s manual

Reference Section

In the Step Type field you have access to all possible steps through the selections menu. The following types

of steps are at your disposal:

1 (Empty) Step without a function; use this as a placeholder when creating a step list. It

might be especially useful when you know that a step will be added at this location but

you do not know what kind of step.

2 Activate patch Activates a selectable patch. After selecting the function a window will

open where you may enter the patch. To close the window press

OK to accept the

selection. Click on

Cancel to abort the procedure.

3 Play Plays the patch and corresponds therefore to pressing the PLAY key on the operation

panel of the remote controller.

4 Pause Stops the playback and corresponds to pressing the STOP key once on the opera-

tion panel of the remote controller. The song position will not be changed, the additional

command START resumes the playback from the same position it stopped.

5 Stop Stops the playback and corresponds to pressing the STOP key twice in the operation

panel of the remote controller. The song position is set to the beginning of the song and

the additional command START replays the song from the beginning.

6 Send MIDI data Opens the possibility to add MIDI data (System-Exclusive-Files/Sys-

Ex-Files) into the step list. This is a file format that allows a wide range of programming

of a connected MIDI device, through the MIDI standard. The programming of Sys-Ex-

Files requires an extensive technical knowledge that this manual cannot provide. Please

consult technical literature for this.

You should only enter data in this window if you are aware of the consequences. Faulty Sys-Ex-Files may reprogram

MIDI devices to the point of making a proper function impossible.