User Guide
6
midlandusa.com
Antenna Installation
Follow the manufacturer’s installation instructions carefully.
Warning: Never operate your CB radio without attaching an antenna or with a
broken antenna cable. This will result in damage to transmitter circuitry.
Safety notice: The antenna used for this radio must be installed to provide a
separation distance of at least 8 in. (20cm) from all persons and must not be
co-located or operating in conjunction with any other antenna or transmitter.
Tuning Your Antenna
Some antennas are factory tuned. However, performance can usually be improved by
slightly lengthening or shortening the antenna using a Standing Wave Radio (SWR)
meter. For the exact procedures to be used, refer to the antenna manufacturer’s
installation manual.
You can buy an SWR meter separately or have your antenna checked by your Midland
CB Dealer’s service department.
Range
Essentially, the things that affect range are the same inuences that optimize or limit
AM and FM broadcast signals.
Terrain: Hills, valleys and buildings naturally interrupt and shorten CB signals. In short,
anything that is between you and the person you want to talk to can shorten your CB
range. You can expect to maintain maximum transmitting/receiving performance in
at, open country.
Weather: You can expect that CB range will be reduced – perhaps drastically – in times
of atmospheric disturbance, such as in a thunderstorm or heavy snow. Sunspots are
also known to adversely affect CB performance.
Noise
A common source of excessive noise is the ignition system. In many vehicles today the
electric fuel pump is another possible source of noise. If you suspect this is true, turn
off the ignition. With the CB in receive mode, if the noise is no longer present then
this is the source of the noise. In some cases the noise can be reduced or eliminated
by making sure the CB radio chassis is grounded. In addition to the power cord. In
extreme cases, additional grounding of components may be necessary.