User Manual

4. PRI monitor function is not available in this mode. If scan is
stopped, Add/Delete of Group B channels is available in
Add/Delete mode.
5. Other operation is the same as type “A” scan.
TYPE “B’ ” SCAN MODE
1. Operation is the same as type “B” scan, except the SCAN button
operation is the same as type “A” scan.
2. If scan is stopped, Add/Delete of Group B channels is available in
Add/Delete mode.
TYPE “PS” SCAN MODE
1. The “A” channels will be scanned in this mode.
2. The transmit priority and priority monitoring channel will be the
channel that was set when scan was activated.
3. To change the “PRI 1” channel, rotate the channel selector while
in the scan mode or during OFF HOOK SCAN stop.
4. Deleting a nuisance channel is the same as type “A” scan.
5. Adding or deleting the “PRI 2” channel is the same as type “A”
scan.
6. If scan is stopped, Add/Delete of Group A channels is available
in Add/Delete mode.
TYPE “GRP A” MODE
1. Transmit will occur on the currently displayed channel.
2. To change the LAST HOLD CHANNEL rotate the channel selector
during scan.
3. It is not possible to add or delete scan channels.
4. Channel returns to the LAST HOLD CHANNEL, when scan is
stopped by the operator.
5. Other operation is the same as type “A” scan
TYPE “S CH” MODE
1. If the radio is stopped scanning on the “PRI 1” or “PRI 2” then
transmit will occur on the corresponding “PRI” channel.
2. It is not possible to add or delete scan channels in this mode.
Other operation is the same as type “A” scan.
5
MONITOR BUTTON
Press and immediately release the MON button to
disable the receive Coded Squelch function for
adjustment of squelch and volume and to check for
busy channel. Press and release again to re-enable
the coded squelch. In case the MON button is held
more than 1 second the MON button must be held
again more than 1 second to release the monitor
mode.
A/D BUTTON
Press A/D to activate Add/Delete Mode. For detailed
information see the following description of scan
operation
.
AUX BUTTON
Press AUX to access Auxiliary functions
CHANNEL DISPLAY
Indicates selected channel number and is always
illuminated when radio is on. During scan operation,
indicates selected channel or received channel.
DISPATCH OPERATION
SELECTING CHANNELS
If your radio is equipped with more than one channel, rotate the
channel knob to select available channels. Consult your dispatcher for
proper usage.
MESSAGE RECEIPT (RECEIVE)
If a signal exists on the displayed Channel, and you are within radio
range of the sender, you will hear it on the loudspeaker.
NOTE: Your radio may be equipped to block communications from
radios not in your radio system (coded squelch feature), or it may
even block calls from your system that are not directed to you (select
call feature).
2
I20
A/D
AUX
MON