User's Manual

10
4. Mount the bracket using two self-tapping screws and flat washers.
5. Mount the speaker into the bracket using the mounting knobs removed in step 1.
6. Remove the white connector on the rear of the radio. Note that this is a jumper to connect
the internal speaker. Use tape or a nylon strap to attach this connector to one of the cables
on the radio to avoid losing it. It is required to reconnect the internal speaker if the radio is
removed for testing.
2.1.6 ANTENNA INSTALLATION
The recommended location for the antenna is on the roof or trunk (boot) lid.
1. Follow the instructions supplied with the antenna for installation.
2. Install the cable and route it to the rear of the radio.
3 Connect the cable to the antenna connector of the radio.
4. When installation is complete, use a thru-line wattmeter to adjust the antenna for best SWR.
2.1.7 PROGRAMMING
Programming instructions are too extensive to be included in this manual. Please refer to the separate
Programming Manual supplied with the program kit. Programming is done using a PC (Personal
Computer). A portable lap-top computer is recommended so that the radio may be programmed in the
vehicle.
A KG208 6KEN programming kit is available from your dealer. It consists of a detailed manual, software
and an interface cable.