User's Manual

19
SHIFT, C DTMF Clear
Clears any new DTMF entry that may have been entered in error. Example, if the desired number is
12345 and you have entered 13345, press SHIFT, C to erase 13345, then enter the correct number
12345.
C (no SHIFT) Instant Channel Selection
C, followed by keypad entry of a channel number followed by C again will instantly select that channel.
Example: C 1 2 C will select channel 12. The display will flash the new channel several times before
switching. If an unprogrammed channel is selected, the radio will BEEP and return to the original
channel. If the final C is not entered, the radio will wait for two seconds, then switch to the selected
channel. This feature is helpful if you are using a large number of channels.
SHIFT, D Sends Call
In DTMF Mode,
sends sequence of DTMF digits immediately after entry. Example: The operator enters
sequence 1 2 3 4 5 then pressed D to send the call.
In 5Tone mode
, sends R (repeat) 5Tone sequence.
D (no SHIFT) Send 5Tone) or Redial (DTMF)
In 5Tone mode
, sends or redials displayed sequence entered by keypad. If sequence is selected from
memory (see SHIFT 3), it is sent only one time, then the radio reverts to the previously displayed digits.
In DTMF mode
, redials the previously sent digits after first sending with SHIFT D (see above). If D is
pressed while entering a sequence, the radio accepts it as a digit in the sequence. If sequence is selected
from memory (see SHIFT 3), it replaces the previous entry and is sent each time the D is pressed.