User's Manual

70-3350/5445 – User’s Manual
4) Press the buttons until Call 1 or Call 2 is highlighted, then press menu/↵ to make the call. The device will
automatically return to the standby screen.
9.2.c Sending a variable selective call
The selective variable is only available through the keypad microphone (mod. MK06/35-K).
If the channel has been programmed to emit a selective variable, a * symbol will appear on the bottom left of the
display, followed by the predefined variable digits. A selective variable can be sent using two methods:
Emission via microphone
Key in the variable digits using the microphone keypad, then press the *CALL button on the microphone.
Emission via the menu
1) Key in the variable digits using the microphone keypad.
2) Follow steps 2 and 3 from the par. “Sending a fixed selective call from the menu”.
3) Press the
buttons until User Call is highlighted, then press menu/↵ to make the call.
9.2.d Sending an emergency selective call
This is a special call that is sent repeatedly in cycles on a predefined channel based on the radio’s programming.
 Use this emergency call only if you find yourself in a real condition of necessity which requires assistance. Speak to
your radio network administrator about its use.
 Your radio can be programmed to deactivate all other commands when it is making an emergency call.
 An emergency call can also be sent using the Input/Output connector.
Emission via microphone
Hold down the 3EMG button on the keypad microphone until the emergency selective call is emitted, then release.
Emission via the menu
1) Follow steps 1 and 3 from par. “Sending a fixed selective call from the menu”.
2) Press the
buttons until Emergency (emergency call) is highlighted, then press menu/↵ to make the call.
Rev. 0.1 on 27 December 2004 Page 23 of 32