User's Manual

KYODO KG510 OPERATORS MANUAL
128113 Page #25 of 26 Pages 11 December, 2000
4.21 Serial Number Display
It is possible to display the KG510's Serial Number in the LCD Display. To do so, the Serial Number
must be entered into the <Configuration Menu> <Serial No.> field during the programming of the
radio. The serial number can be up to eight characters long and can comprise of any of these
characters:
"A - Z" & "0 - 9".
Holding the [D] key pressed while switching the POWER SWITCH "ON" places the KG510 in Serial
Number Display Mode and displays the KG510's Serial Number in the LCD Display as shown below:
Switch the KG510 "OFF" to exit from the Serial Number Display Mode.
4.22 EEROM Data Check Mode
As soon as the KG510 is switched "ON", it will automatically read and check all the data in the
EEROM.
If this check finds damaged or corrupted data, the KG510 will automatically enter the Programming
Mode and display the following message in the LCD Display:
Should this happen, it is necessary to return the KG510 to your radio supplier or to a competent radio
trades-person who has the facilities to reprogram the KG510.
Serial KY000727
EROM Data Error