MODEL 75-820 40 CHANNEL PORTABLE MINI CB WITH 10 CHANNEL WEATHER RECEIVE 5 MEMORY CHANNELS, MEMORY SCAN ALL CHANNEL SCAN, INSTANT CHANNEL 9/19 HI/LO POWER, AUTO POWER SAVE BACK LIGHTED LCD DIGITAL CONTROL SCREEN
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE CONDITION THAT THIS DEVICE DOES NOT CAUSE HARMFUL INTERFERENCE. Your 40 channel Portable CB/Weather Monitor represents the state-of-the art in hightech engineering. Designed for 40 channel Citizen Band operation plus 10 weather channels, this compact package is big in performance. This unit is a quality piece of electronic equipment, skillfully constructed with the finest components.
1. Antenna connector: With BNC connector type. A mobile or base station antenna (adapter required) can be used to extend range. 2. “Squelch” Control: For the maximum receiver sensitivity, the control must be adjusted exactly where the receiver background noise disappears. 3. "ON/OFF" Volume Control. In ‘’OFF’’ position your transceiver is off. Turn this control clockwise to switch on the unit. Turn the knob clockwise a little more to set the audio level, until you get a comfortable sound level. 4.
J. DW: Illuminates when the dual watch mode is enabled. K. AM: Indicates the CB mode is activated. L. “F”: Indicates the function button has been activated. The function mode allows use of the modes inprinted on the function buttons face. M. “M/1”: Indicates the memory channel selection. N. SCAN: Illuminates to indicate the scan mode is activated. O. WX: When visible indicates your transceiver is in the weather receive mode. Select the appropriate channel with the up/down buttons. 5.
To program memory channel 2 follow the instructions for programming memory channel 1, except substituting channel 2 for channel 1. c. “M3 SC Button”; To start scan, set the squelch to mute the background noise. Press and release the “SC” scan button, scan will begin. The scan will stop on all channels where a signal is received with enough strength to open the squelch. The squelch will remain stopped for a few seconds after the signal disappears to allow time to answer the call.
f. “M.SC H/L Button”; To change between high and low power, press and release the H/L button. To scan only the 5 channels in memory locations 1 through 5, press the “F” function button and release, then press and release the “M.SC” button. To stop memory scan, press the up, down, or PTT button. HOW TO OPERATE YOUR TRANSCEIVER FOR CB 1. Insert the antenna in the antenna connector. 2. Insert 6 alkaline or nic-cad batteries into the battery compartment, noting polarity. 3.
SPECIFICATIONS CB Channels Power Output Modulation TX Dist Spurious and Harmonics Receiver Sensitivity Audio output Selectivity 1 through 40 4 watts nominal 90% +/- 5% <5% <-60dbc 0.7 uv for 10 db s/n 4 watts 50 db SPECIFICATIONS WEATHER RECEIVER CHANNELS 00 163.275 05 162.450 01 162.550 06 162.500 02 162.400 07 162.525 03 162.475 08 161.650 04 162.425 09 161.775 Sensitivity Audio Power Audio Load 0.
LIMITED WARRANTY Midland Consumer Radio Inc. will repair or replace , at its option without charge, any Midland Mobile, high power portable, FRS, or Base Station Citizens Band trancseiver which fails due to a defect in material or workmanship within one year following the initial consumer purchase.