User Manual

If you choose the Clear To Talk setting, your choices include On or Off settings. You can toggle between these settings with
the up or down buttons. When the desired setting appears on the display, press the MODE button
to select. The radio will save your selection and return to standby mode. Example of display:
.
NOTE: If you select On, the radio issues a beep tone when pressing the P-T-T button, letting you know that speaking may
begin.
If you choose the Roger Beep setting, your choices include On or Off settings. You can toggle between these settings with
the up or down buttons. When the desired setting appears on the display, press the MODE button to select. The radio will
save your selection and return to standby mode.
An example of the Roger Beep display:
.
NOTE: If you select On, the radio issues a beep tone after TX is completed to confirm the transmission has finished.
If you choose the 2 Tone Alarm setting, your choices include On or Off settings. You can toggle between these settings with
the up or down buttons. When the desired setting appears on the display, press the MODE button to select. The radio will save
your selection and return to standby mode.
An example of the 2 Tone Alarm display:
.
NOTE: If you select On, the radio issues an alarm tone after a 2 tone signal is decoded and RX carrier is no longer present if
a call is received during the alarm the alarm will stop until the call is gone. Once the RX signal is no longer present the alarm
will continue until the 2 tone decode is reset by pressing the AUX button for 3 seconds.
If you choose the Microphone Hook setting, your choices include On or Off settings. You can toggle between these settings
with the up or down buttons. When the desired setting appears on the display, press the MODE button to select. The radio will
save your selection and return to standby mode.
An example of the Microphone Hook display:
.
NOTE: If you select On, the Microphone hub will not require ground to activate privacy tones.
If you choose the Microphone Hook setting Off, the Hook Scan setting will appear, your choices include On or Off settings.
You can toggle between these settings with the up or down buttons. When the desired setting appears on the display, press
the MODE button to select. The radio will save your selection and return to standby mode.
An example of the Hook Scan display: .
NOTE: If you select Microphone Hook setting Off, the Microphone hub will require ground to activate privacy tones if
microphone hub is removed from ground privacy tones are defeated and the radio will operate in carrier squelch mode. If you
select Hook scan On, your radio will continue to scan with the microphone hub not grounded in carrier squelch mode.
If you choose the Audio Compander setting, your choices include On or Off settings. You can toggle between these settings
with the up or down buttons. When the desired setting appears on the display, press the MODE button to select. The radio will
save your selection and return to standby mode.
An example of the Audio Compander display:
.
NOTE: If you select On the audio quality between wide and narrow band channels will be the same.
For quick reference, the next few pages detail the System Option Menu, sub-menus and their settings.
S
y
stem O
p
tion Settin
g
Beep Tone
Bee
p
On/Off
VOX Option
VOX On/Off
VOX Sensitivity
Level 1 ~ Level 3
TOT On 1 ~ 990 sec