Operation Manual

CONTENT

› 1 portable CB transceiver

› car adapter with SO 239 external antenna jack

FUNCTION AND LOCATION OF THE CONTROLS

1. Antenna connector

2. Squelch Control: this control cancels the background noise of the

receiver. By turning the knob to the right the function is activated, by

turning the knob to the left the function is deactivated. The knob should

be regulated exactly at the point where the receiver background noise

disappears.

3. On/Off Volume Control.

In ‘’off’’ position your transceiver is off. Turn this control clockwise to

switch on the unit. Turn the knob clockwise a little more to set the audio

level, until you get a comfortable reception.

4. MIC jack: connect by inserting the loudspeaker mike to the plug.

5. External loudspeaker jack: connect by inserting the loudspeaker mike

to the plug.

6 Multifunction backlighted display.

This liquid crystal display has been projected to show the operative

modality:

a. EMG function activated

b. Channel selected number( from 1 up to 40)

c. Lock: keyboard lock function activated

d. BATT: Run-down batteries indicator

e. AM/FM mode

f. SC: SCAN function activated

g. DW: DUAL WATCH function

h. LOW function activated

i. The received signal strength and the power of the transmitting signal

j. RX/TX: TX=transmit mode; RX=receive mode

k. Frequency band selected

7. EMG button: emergency channel. By pressing this button, the unit

automatically skips to Channel 9 (emergency channel). The display will

show EMG. It will not be possibile to change accidentally the channel. To

cancel this function, press the button again.

8. A/F–LCR button: to select AM mode or FM mode; the modulation

you choose will appear on the display. If you select a frequency band

operating in FM mode only, the A/F–LCR button will activate the LCR

function (Last Channel Recall).

9. Microphone: during transmission, keep your mouth 4 cm far from the

unit, and speak with a normal tone of voice to the microphone.

10. H/L button: it selects the output power level during trasmission.When the

unit is turned on, it always transmits with high power (4W). By pressing