Owner's Manual

Model BR180

midlandusa.com

Page 16

RADIO TO RADIO CLONING

The settings from a BR180 radio can be directly transferred to another BR180 radio,

bypassing the need to individually program radios. The BA22 cloning cable is required and

is listed in the back of this manual and available on the www.midlandusa.com website.

1. Turn off both radios.

2. Connect the programmed (Host) radio to the radio to be programmed (Clone) using

the BA22 Cloning cable.

3. Turn on the Host radio.

4. Press and hold both the Up and Down arrow buttons and turn on the radio to

be Cloned.

a. “PROGRAM” will flash in the display to confirm you are in Cloning mode.

b. The display will count upwards to 100 to show the data transfer.

c. The Cloned radio will restart after cloning is complete.

5. Unplug the radios and check the radios’ operation as the final conformation.

FULL FACTORY RESET

You can reset the radio to its original factory (default) settings by pressing and holding

down the TALK and UP Channel/Menu arrow buttons while turning the radio on.

FREQUENCIES

The radio comes pre-programmed with the most commonly used Frequencies and Privacy

Codes already assigned to a channel.

DEFAULT FREQUENCIES AND PRIVACY CODE CHART

You may change the channel assignment using the FREE Programming Software or the

Keypad Programming as shown above.

NO.

Frequency

(MHz)

Frequency

Code

Number

Privacy

Code

Privacy

Code

Number

1 464.5500 55 67.0 1

2 467.9250 85 67.0 1

3 467.8500 79 67.0 1

4 467.8750 81 67.0 1