Troubleshooting Guide

Model BR200
midlandusa.com
Page 7
INSTALLING EXTERNAL ACCESSORIES
Pull the accessory jack cover to the side exposing the speaker/mic jacks.
Insert the accessory plug into the speaker/mic jack, making sure it is securely in
place and has made a good connection.
1. Plug the DC barrel plug on the adaptor cord into the connector on the
back of the charging base.
2. Plug the AC adaptor into a 120V AC wall outlet, making sure the AC outlet
has power.
• The charger’s LEDs turns green when power is present.
3. Make sure the battery contacts and charge terminals are clean and in good
condition.
INSTALLING THE BELT CLIP
With the back of the radio facing you, align the BELT CLIP with the screw holes
on the radio. Attach the BELT CLIP with the Phillips-Head screws that came
with the belt clip.
Be careful not to over tighten screws to avoid
damaging radio chassis.
CHARGING THE BATTERY PACK
Your radio is equipped with a Lithium-Ion battery pack which can be recharged
by inserting the radio or battery into the desktop charger (as described below).
You should charge the battery pack when the Charge Battery Alert comes on,
and remove the radio from the charger when the charging is finished.
To charge using the Desktop Charger: