Operation Manual
16
Enter SETUP mode Press the Control button for 7 seconds while the unit is o
Exit SETUP mode While in Setup mode, double click the Control button. The Red light will turn o and
the Blue light starts ashing.
Pairing a Phone
While in Setup mode, press the Control button until the LED light ash Red and Blue
alternately
Pairing your BTCity with another BTCity device
While in Setup mode, press the Volume + on one unit (the light will ash Red and
Blue alternately), press the Volume- on the other unit (the light will ash Red and
Blue alternately). On a successful pairing, both light turn to Blue for one second.
Reset all paired devices
While in Setup mode, long press he Volume + and he Volume -. On a successful reset,
the Blue light will turn on for two second.
SPECIAL SETUP CONFIGURATION
Change VOX sensitivity or disable it
While in Setup mode, press short the Control and VOL+ buttons (blue light on).
Now, press “Volume +” or “Volume-“ to increase or reduce sensitivity. Double click
the Control button to visualize the VOX status. Go back to the SETUP mode (Red light
always on).
VOX STATUS (Blue light ashing):
Once = VOX disable
Twice = very low sensitivity
3 times = low sensitivity
4 times = medium sensitivity.
5 times = high sensitivity
Wired connection always on
Enabling: In “Setup” mode, press the “Volume+” and “Volume -” buttons for one
second. The blue LED will ash once.
Disabling: Follow the same procedure up described; now the blue LED will ash
twice
Intercom and GPS
Disabling: Enter the “Setup” mode. Press the “Control” and “Volume -” buttons for
one second. The blue LED will ash once. To exit the “Setup”mode double press the
“Control” button.
Enabling again: Follow the same procedure up described; now the blue LED will
ash twice. To exit the “Setup”mode double press the “Control” button.
CTE International herewith declares that the product complies with the essential requirements of EC Directive 99/05/EC; the declaration of confor-
mity of the device can be consulted onto www.midlandradio.eu