User guide

Exit SETUP mode While in Setup mode, double click the Control button. The

Red light will turn off and the Blue light starts ashing.

Pairing a Phone While in Setup mode, press the Control button until the

LED light ash Red and Blue alternately

Pairing your BTSKI with another BTSKI

device

While in Setup mode, press the Volume + on one unit (the

light will ash Red and Blue alternately), press the Volu-

me- on the other unit (the light will ash Red and Blue

alternately). On a successful pairing, both light turn to Blue

for one second.

Reset all paired devices While in Setup mode, long press he Volume + and he Vo-

lume -. On a successful reset, the Blue light will turn on

for two second.

SPECIAL SETUP CONFIGURATION

Change VOX sensitivity or disable it While in Setup mode, press short the Control and VOL+

buttons (blue light on). Now, press “Volume +” or “Volume-“

to increase or reduce sensitivity. Double click the Control

button to visualize the VOX status. Go back to the SETUP

mode (Red light always on).

VOX STATUS (Blue light ashing):

Once = VOX disable

Twice = very low sensitivity

3 times = low sensitivity

4 times = medium sensitivity.

5 times = high sensitivity

Wired connection always on Enabling: In “Setup” mode, press the “Volume+” and “Vo-

lume -” buttons for one second. The blue LED will ash

once.

Disabling: Follow the same procedure up described; now

the blue LED will ash twice