Instructions

UK
www.midlandeurope.com 35
To perform this operation you must first enter the setup mode:
› Turn o the unit
› Press and hold down the “Middle” button about 7 sec., until the Red light is on per-
manently.
› Then simultaneously press and hold down all the three buttons “Forward”-“Midd-
le”-“Backward” for 3 seconds. The Blue Light will be lit on for 1 sec and than back to
steady RED.
› Double click on the “Middle” button to exit the “Setup” mode and use the Midland
BTNEXT PRO
Adjusting/ Disabling the VOX feature (Intercom and telephone)
The Intercom feature can be enabled both manually and vocally (VOX). The VOX activa-
tion is influenced by the helmet type, the background noise and therefore by the speed.
For optimum results, it is possible to choose one of the following four microphone sensi-
tivity levels: high, medium, low and very low. It is also possible to disable the VOX feature
in order to activate the Intercom and phone call answering features in manual mode only.
Adjusting the sensitivity of the (VOX)
To perform this operation you must first enter the setup mode:
1. Turn o the unit
2. Press and hold down the “Middle” button about 7 sec., until the Red light is on per-
manently.
3. Your Midland BTNEXT PRO is now in “Set up mode”.
4. Press the “Backward” button shortly and the red light changes to a steady blue.
5. Now, press “Volume +” or “Volume -“ to increase or reduce sensitivity. Every time you
press the Volume buttons the RED light will flash for confirmation. When you reach
the end of the upper and lower limit, the RED light will not flash.
6. Press again the “Backward” button shortly; the Blue light will flash several times, in
order to let you know the selected sensitivity:
One flash = VOX disabled
Twice = low sensitivity
3 times= normal sensitivity
4 times= high sensitivity
5 times = Highest sensitivity
The light indicator is now back to steady RED (“Set up mode”) and the changes are
confirmed
7. If needed, you can adjust again the sensitivity repeating the steps from point 1, other-
wise exit the Setting mode by double clicking the “Middle” button. Once the red light
turns o, the blue led starts blinking. Now you can use your Midland BTNEXT PRO
Disabling the VOX feature (Intercom and telephone)
Follow all the procedure described in the previous steps and choose the option of only
one flash (VOX disabled).
Attention! If you disable the VOX feature, you will be able to answer incoming phone calls
only by pressing the “Forward” button.
Wired connection always in background
This feature lets you keep the wired connection always on, even when the phone or the
intercom is open (but not when you are in FM radio mode).
By default the Background feature is ON.
Disabling:
› Enter the “Setup” mode:
› Turn o the unit
› Press and hold down the “Middle” button about 7 sec., until the Red light is on per-
manently.
› Press the “Forward” and “Middle” button together for 3 seconds. The blue LED will
flash three times.
› Double click on the “Middle” button to exit the “Setup” mode and use the BTNEXT
PRO
Enabling:
Follow the same procedure up described; now the blue LED will flash once.
To exit the “Setup” mode, double click the “Middle” button.