Instructions

UK
www.midlandeurope.com 7
MONO
› Phone (HFP Mono)
› GPS mono
› PMR446 Transceiver
MONO and STEREO
› Phone (HFP/A2DP Stereo)
› GPS (HFP/A2DP Stereo)
› Dongle (HFP/A2DP Stereo)
Attention: A2DP audio source are supported only on Vol+. The second phone paired on Vol-
can support only mono audio (HFP).
Background feature
It is possible to keep always in background the audio of the device paired on Vol- button.
In this way the Intercom communication will not be interrupted, for example, by the
GPS’s street indication or other audio mono device.
To activate the “Background” feature just press long the “Vol-” button, the voice “Back
-
ground ON” will tell you that now is active.
To deactivate the “Background” feature just press again long the “Vol-” button, the voice
“Background disable” will tell you that now is not active anymore.
By default the “Background” feature is o.
Attention: we can’t guarantee this feature because it is depending on third part device.
Pairing with one or two phones
The cellular phone can be paired to the “Vol +” (if the support for stereo A2DP is reque-
sted) or to the “Vol –“.
When a phone is paired to the “Vol +” or “Vol-“ the “Phone” mode is activated.
An incoming call has always the higher priority, that means all other communications will
be closed (Intercom, FM Radio, Music).
If another incoming call will arrive on the second phone, an alert sound will notify it.
How to pair the BTX1 PRO to a Phone
To pair the BTX1 PRO to a Phone, you must first enter the setup mode:
1. Turn o the unit
2. Press and hold down the middle button about 7 sec., until the Red light is on per
-
manently.
3. Now press for 3 seconds the “Volume +” or “Volume -” button, the Blue and Red
light will flash.
4. Enable the Bluetooth device search feature on your mobile phone
5. After some seconds, “Midland BTX1 PRO” will be displayed on your mobile phone.
Follow the pairing procedure of your Phone. If a pin code is requested you must enter
“0000” (four time zero).
When successfully paired, the Blue light of the unit will be on for one second and then
the unit will exit the setup mode and switch to the working mode (the Blue light will start
flashing).
You can use now your BTX1 PRO together with the Phone.
How to use a Phone
After pairing your phone to the BTX1 PRO unit you must switch to the “Phone” mode
in order to use it. Press the middle button until you hear “Phone” from the voice an
-
nouncement. Now all the three main buttons are dedicated to the phone (see Table B)
Answering a call
When you hear the phone ring, you can answer in two dierent ways:
Vocally:
Simply say one word to answer the call and start talking.
Manually:
Tap the “Forward” button and start talking.
Rejecting a call
If you don’t wish to answer, you can let the mobile phone ring or press the “Forward”
button for 3 seconds (you will hear one audio confirmation tone).
Making a call
There are several ways to make a call.