Instructions

8 | BR03 instruction guide
Scan
Keep pressed the Function key 2 for about 3 sec. to enable the SCAN
function: the radio will scan all channels starting from the channel in use.
The display of the radio will show a flowing arrow from left to right (scan
upwards); with the UP/DOWN controls it is possible to change the scan
direction (scan downwards).
Whenever a signal is detected, the scan will stop on a busy channel.
With the optional programming software PRG-10 you can choose 3 dif-
ferent scan modes.
The scan mode set by default is the one on the received carrier.
When the signal is no longer detected, the scan will automatically start
again after 7 seconds roughly.
Pressing the PTT will stop the scan and the radio will transmit on the chan-
nel in use.
To start the scana gain, press the Function key 2.
Vox
BR03 enables hands-free conversations through the VOX function: just
speak in the direction of the microphone and the communication will be
automatically activated.
The VOX sensitivity can be adjusted in 10 dierent levels (OFF,1,2,3…9)
through the programming software or the radio menu.
OFF means that the VOX is turned o, 1 is the lowest VOX sensitivity
level and 9 is the highest one.
To adjust the VOX to the desired level through the radio menu, follow
these steps:
• Briefly press the Function key 2.
• Press twice the Function key 1. The display will show the sensitivity level
with the indication “ ”. With the UP/DOWN keys set the desired
level from 0 to 9.
• Confirm by pushing PTT or wait for about 3 seconds.