Instructions

12 | BR03 instruction guide
Troubleshooting
Problem Possible Cause Solution
The radio doesn’t switch
on
The battery pack is di-
scharged and/or has not
been installed correctly.
Verify that the battery
pack is charged and that
it has been correctly
installed.
The radio switches o
shortly after it has been
switched on
Discharged battery pack.
Recharge the battery
pack.
The battery pack does
not recharge
The battery has not been
connected or installed
correctly.
Inspect the connections
of the battery-charger
and the installation of the
batteries.
The radio switches on
but is unable to receive
signals
The site of installation is
too shielded.
Move to an another area.
The volume is too low Adjust the volume level.
Incorrect CTCSS or
DCS
Check that the CTCSS
tone or DCS code
corresponds to the one
set by the parties you are
communicating with.
Noise is always present in
reception mode
The Monitor function is
enabled.
Disable the Monitor
function.
It is not possible to
communicate with other
parties
An incorrect radio chan-
nel has been selected.
Select the same radio
channel used by the
parties you are commu-
nicating with.
The radio is installed in a
shielded area or is too far
from the party you are
communicating with
Move to another area.
Incorrect CTCSS or
DCS
Check that the CTCSS
tone or DCS code
corresponds to the one
set by the parties you are
communicating with.