User's Manual

Model GXT1000/1030/1040/1050/1191 Series
Page 12
midlandusa.com
SETTING PRIVACY CODES
Your radio has 142 Privacy Codes available which can only be used
on channels 1~22. The selected Privacy Code may be different for
each channel. To select a Privacy Code for the current channel press
the MENU button three times, and then the
s\t
buttons to select
between “Off/CTCSS/DCS”. Press the MENU button again and the
s\t
buttons to select one of the 38 CTCSS Codes or one of the 104
DCS Codes.
The Privacy Code icon on the display will indicate whether you set
your Privacy Code in CTCSS or DCS mode. To confirm the selection,
press the PTT button or press the MENU button again to move to the
next feature setting.
Note : If you select a CTCSS Privacy Code, any previously
selected DCS Privacy Code will be cancelled and vice-versa.
Selecting a Privacy Code of "oF" will disable the Privacy feature.
To communicate between two radios, all radios in your group
must be set to the same channel and/or Privacy Code selections.
The Privacy Code can only be set in channels 1~22.
TRANSMIT (TX) POWER LEVEL SELECTION
Your radio has 3 power level settings. To select the power level on
channels 1~7, 15~33 and 38~50, press the MENU button until a “Pr”
icon will appear blinking on the display. Then press the
s\t
buttons
to select TRANSMIT POWER LEVEL icon, “H” for high, “M” for
medium, and “L” for low power. To confirm, press the PTT button or
press the MENU button again to move to the next feature setting.
When the Battery Meter drops to 1 bar , the TX Power will
automatically switch from Hi(H) or Med(M) to Lo(L) level.
Note : You cannot adjust the power setting on channels 8
through 14. These channels are set to Low power per FCC
regulations.
!
!