User Manual
Table Of Contents
- Welcome to the world of Midland electronics
- LCD DISPLAY
- CONTROLS
- BATTERY INSTALLATION
- INSTALLING THE BELT CLIP
- CHARGING THE BATTERY PACK
- OPERATING YOUR RADIO
- POWER ON/OFF AND VOLUME
- TRANSMITTING AND RECEIVING A CALL
- ABOUT RANGE
- LXT600 SERIES QUICK REFERENCE CHART
- MONITOR
- SCAN
- CALL ALERT
- KEYPAD LOCK
- CHANNEL SELECTION (GMRS/FRS BAND)
- SETTING PRIVACY CODES
- Your LXT600 Series has 121 Privacy Codes available to use in channels 1~22. The selected Privacy Code may be different for each channel. To select a Privacy Code for the current channel press the MENU button twice, and then the ▲\▼ buttons to select one o
- TRANSMIT (TX) POWER LEVEL SELECTION
- Your LXT600 has 2 power level settings. To select the power level on channels 1~7 and 15~36, press the MENU button until a “Pr” icon will appear blinking on the display. Then press the ▲\▼ buttons to select TRANSMIT POWER LEVEL icon (H: Hi/L: Lo). To conf
- VOX
- Your LXT600 Series has 3 VOX level settings: (oF/1/2/3).
- ROGER BEEP (end of transmission) TONE
- CALL ALERT SELECTION
- SILENT OPERATION
- Your LXT600 Series has a SILENT OPERATION mode. In this mode, all “beeps” and “tones” are disabled.
- NOAA WEATHER RADIO/SCAN
- Your LXT600 Series has a NOAA WEATHER RADIO function, to enable the user to receive weather reports from designated NOAA stations.
- EXTERNAL SPEAKER/MICROPHONE JACK
- TROUBLESHOOTING GUIDE
- USE AND CARE
- ACCESSORIES
If you have a problem which you believe requires service,
please call first and speak with a service technician at
816-241-8500. Many problems can be remedied over the phone
without returning the unit for service.
TROUBLESHOOTING GUIDE
PROBLEM SOLUTION
No Power - Check battery installation and/or replace batteries
Cannot Receive
Messages
- Confirm the radios have the same channel settings.
- Make sure that you are within range of the other
transceivers.
- Buildings and other structures may interfere with
your communication.
Radio is not responding
to button presses
- Make sure key lock is not on (See Keypad Lock).
- Radio might need to be reset. Turn radio off then
on.
Display is dim - Recharge or replace batteries.
Charger not functioning
- Contacts on the bottom of the radio may require
cleaning.
- Ensure the outlet where the charger is plugged in is
functioning properly.
- Check that the battery pack is installed in the radio
properly.
USE AND CARE
1. Use a soft damp cloth to clean the radio
2. Do not use alcohol or cleaning solutions to clean the radio.
3. Do not immerse the radio in water.
4. Dry the radio with a dry lint-free cloth should it get wet.
5. Turn off the radio and remove the batteries during long-term
storage.