User Manual
Table Of Contents
- Welcome to the world of Midland electronics
- LCD DISPLAY
- CONTROLS
- BATTERY INSTALLATION
- INSTALLING THE BELT CLIP
- CHARGING THE BATTERY PACK
- OPERATING YOUR RADIO
- POWER ON/OFF AND VOLUME
- TRANSMITTING AND RECEIVING A CALL
- ABOUT RANGE
- LXT600 SERIES QUICK REFERENCE CHART
- MONITOR
- SCAN
- CALL ALERT
- KEYPAD LOCK
- CHANNEL SELECTION (GMRS/FRS BAND)
- SETTING PRIVACY CODES
- Your LXT600 Series has 121 Privacy Codes available to use in channels 1~22. The selected Privacy Code may be different for each channel. To select a Privacy Code for the current channel press the MENU button twice, and then the ▲\▼ buttons to select one o
- TRANSMIT (TX) POWER LEVEL SELECTION
- Your LXT600 has 2 power level settings. To select the power level on channels 1~7 and 15~36, press the MENU button until a “Pr” icon will appear blinking on the display. Then press the ▲\▼ buttons to select TRANSMIT POWER LEVEL icon (H: Hi/L: Lo). To conf
- VOX
- Your LXT600 Series has 3 VOX level settings: (oF/1/2/3).
- ROGER BEEP (end of transmission) TONE
- CALL ALERT SELECTION
- SILENT OPERATION
- Your LXT600 Series has a SILENT OPERATION mode. In this mode, all “beeps” and “tones” are disabled.
- NOAA WEATHER RADIO/SCAN
- Your LXT600 Series has a NOAA WEATHER RADIO function, to enable the user to receive weather reports from designated NOAA stations.
- EXTERNAL SPEAKER/MICROPHONE JACK
- TROUBLESHOOTING GUIDE
- USE AND CARE
- ACCESSORIES
OPERATING YOUR RADIO
POWER ON/OFF AND VOLUME
Rotate the POWER/VOLUME knob clockwise to turn the radio on and
increase the volume level. Rotate the control counter-clockwise to
reduce the volume level and to turn the radio off. During Power On,
the radio will beep 2 times with different tones, the LCD will display all
icons for 1 second and the LCD display will indicate the last channel
selected.
TRANSMITTING AND RECEIVING A CALL
To communicate, all radios in your group must be set to the same
channel.
1. For maximum clarity, hold the radio 2 to 3 inches from your mouth.
2. Press and hold the PTT button and speak in a normal voice into
the microphone. The TX icon will appear continuously on the LCD
display while transmitting.
3. To receive a call, release the PTT button. The RX icon will appear
on the display when your radio is receiving a transmission.
ABOUT RANGE
Your LXT Series radios are designed to give you maximum range
under optimum conditions.
l Over water
l Open rural areas without obstructions
l Flat areas where you can see the other person
To ensure you get maximum range:
l Be sure to use fresh or fully charged batteries - low batteries will
cause low power conditions.
l Be sure you are on a GMRS channel - FRS channels are
restricted by the FCC to low power.
l Be sure to set your radio to use Hi power.