Installation Instructions

Page 16
midlandusa.com
Model MXT400
3. Press and hold the Scn/Mon button to enter Monitor mode.
You will hear any activity on the current selected channel.
4. Rotate the
Volume Knob to increase or decrease radio volume.
5. Once the radio volume has been adjusted to the desired level, press
and hold the Scn/Mon button to exit
Monitor mode.
Scanning for Active Channels
Your MXT400 includes an “auto-scan” mode that continuously scans all 15
GMRS channels for activity.
To enter and exit “auto-scan” mode:
1. Be sure the radio is turned on (see Power On/Off)
2. Quickly press and release the Scn/Mon button to enter “auto-scan” mode
Your radio will rapidly scan through the 15 GMRS channels and will
pause on any active channel.
“Auto-scan” will resume when there has been no activity on the
current channel for four seconds.
3.
To transmit during “auto scan,” press and hold the PTT button on the
microphone while the radio is paused on the desired channel.
The radio will remain on the active channel for three seconds after
the
PTT button is released.
4. To exit the “auto-scan” mode, quickly press and release the Scn/Mon
button.
Call Alert
To send a call alert
1. Press and release the CALL button.
The TX indicator will enable while transmitting a call alert and a tone
Scan Skip allows channels to be removed from the scan list. The “M” icon on
the left side of the display indicates the channel is currently in the scan list.
1. Select the channel you would like to remove from the scan list.
2. Long press the Menu button. The M icon should turn off indicating the
channel will not be scanned.
3. To add back a channel previously removed, select that channel and long
press the Menu button again. The M icon will turn on indicating the
channel has been restored to the scan list.