Owner's Manual

Model T10 & T30 Series
Page 8
midlandusa.com
Optimum Conditions are:
l Over water
l Open rural areas without obstructions
l Flat areas where you can see the other person
To ensure you get maximum range:
l Be sure to use fresh or fully charged batteries - low batteries will
cause low power conditions.
l Be sure to set your radio to use Hi power.
T10 & T30 SERIES QUICK REFERENCE CHART
MONITOR
Pressing and holding the MONITOR button for 3 seconds will let you
hear noise so you can adjust the volume level of the radio when not
receiving a signal. This could also be used to check any activity on
your current channel before transmitting.
Press and hold the MONITOR button for 3 seconds again to get out
of MONITOR mode.
SCAN
Your radio can scan all 22 channels for activity. To enter, quickly press
the SCAN button. Repeat the same procedure to exit. Your radio will
rapidly scan each of the 22 channels and stop on any active channel
for 6 seconds before resuming scan.
When you press the PTT button to transmit on an active channel, the
scanning function will stop and remain on the active channel. To
resume scanning, quickly press the SCAN button.
MENU
Channel
VOX
1~22
CTCSS
Roger Beep
On/Off
Silent Operation
On/Off
WX Channel
1~10
WX Alert
On/Off
Press and hold UP/WX
button for 5 seconds
oF~38
On/Off