Owner's Manual
Table Of Contents
- Owner's Manual
- Features
- Important Notice
- LCD Display
- Controls
- Battery Installation
- Installing the Belt Clip
- Charging the Battery Pack
- Battery Level Indicator
- Operating Your Radio
- T50 Series Quick Reference Chart
- Monitor
- Scan
- Call Alert
- Keypad Lock
- Channel Selection (FRS Band)
- Setting Privacy Codes
- Transmit (TX) Power Level Selection
- VOX
- Roger Beep (end of transmission) Tone
- Call Alert Selection
- Vibrate Alert (Model T75 Only)
- Silent Operation
- NOAA Weather Radio/Scan
- NOAA Weather Alert
- External Speaker/Microphone Jack
- Troubleshooting Guide
- Use & Care
- Specs
- DCS Privacy Code Chart
- Warranty
- Accessories
- Weather App Information
Model T70 Series
Page 5
midlandusa.com
BATTERY INSTALLATION
Your radio operates with either a NiMH battery pack or optional 3 AA
alkaline batteries. The belt clip should be removed (see below) to
ease installation or removal of the batteries.
To install the batteries:
1. With the back of the radio facing you, remove the belt clip (see
diagram below) for easy access, then remove the Battery Cover by
pressing down on the top center and sliding it down from the radio.
2. Insert NiMH battery pack or 3 AA batteries observing the polarity
as shown. Installing the batteries incorrectly will prevent the unit
from operating or may damage the unit.
3. Return the Battery Cover by sliding it up on the radio. Replace the
belt clip, making sure it locks into place.
BATTERY
COMPARTMENT
BATTERY
COMPARTMENT
COVER
Press here and
push down to open
BELT CLIP
LOCK TAB
BELT CLIP
LATCH
INSTALLING THE BELT CLIP
To install the BELT CLIP, slide the clip down into the slot on the back
of the radio until the BELT CLIP LATCH clicks. To remove the BELT
CLIP, pull the LOCK TAB away from the radio, then gently pull the
belt clip up toward the top of the radio.