User's Manual

Specifications
Batteries: ................................. AAA (qty: 2)
(Note: Battery access cover is located on back of controller)
Range of Operation ................. 20 ft (6 m) radius
This procedure is only required if there is a malfunction, or
if you are attempting to use the controller with a chair other
than the one it was originally associated with.
Troubleshooting
• When any button is pressed, hand / foot control
sounds a single “beep”. (All functions operate)
Cause: Low Battery
Solution: Replace batteries
• When any hand / foot control button is pressed,
nothing happens. (No “beeps”, no movement, etc.)
Causes: 1. Batteries completely dead
2. Wireless controller has lost
“association” to chair.*
Solution: 1. Replace batteries
2. Perform Association Procedure*.
* The wireless controllers will only function with the
chair they have been “associated” with. This
prevents unwanted movement in locations with
more than one chair.
If further service is required,
contact your authorized Midmark dealer.
Association Procedure:
A. Using the wired hand / foot control, press & hold
the Stop & Home buttons simultaneously.
(after two seconds you will hear a single “beep”)
B. Using the wireless hand / foot control, press & hold
the Stop & Home buttons until you hear three “beeps”.
(one long “beep” indicates the association failed. Repeat Steps A & B)
C. Check for proper operation of wireless controllers.
Note: Step B must be performed within 10 seconds of Step A,
failure to do so will cause the procedure to fail.