Manual

ManualsBrandsMidNite Solar ManualsWind TurbineMidNite Solar MNCHINOOK200-48 Micro-Turbine

MNCHINOOK DIVERSION LOAD

PRODUCT SPECIFICATIONS MANUAL

17722 67th AVE NE

Arlington, WA 98203

P:360-403-7207

F:360-691-4862

www.midnitesolar.com

The MidNite Chinook Diversion Load (MNCDL) is an integrated solution

designed to prevent 12, 24 or 48 volt batteries from overcharging. It is

designed to be used with 300 Watt or smaller turbine systems.

Compact and easy to install, the CDL incorporates a 300 Watt resistive

heating element

and controller board in a powder coated steel

enclosure.

Summary of content (7 pages)

PAGE 1
MNCHINOOK DIVERSION LOAD PRODUCT SPECIFICATIONS MANUAL The MidNite Chinook Diversion Load (MNCDL) is an integrated solution designed to prevent 12, 24 or 48 volt batteries from overcharging. It is designed to be used with 300 Watt or smaller turbine systems. Compact and easy to install, the CDL incorporates a 300 Watt resistive heating element and controller board in a powder coated steel enclosure. 17722 67th AVE NE Arlington, WA 98203 P:360-403-7207 F:360-691-4862 www.midnitesolar.
PAGE 2
MNCDL INSTRUCTIONS CONTINUED CHINOOK DIVERSION LOAD SPECIFICATIONS- 300 WATT MODELS Operation • • • • • PWM (Pulse Width Modulation) for highest charging performance without flicker Three Stage Charging Selectable for sealed or flooded batteries using jumper Status and fault indicator LEDs Connects directly to the battery bank 12V Version MNCDL300-12 • • • Operating voltage range: up to 15VDC Recommended fuse or circuit breaker: 30 Amps Integrated Load Resistor: 0.
PAGE 3
MNCDL INSTRUCTIONS CONTINUED Weight & Dimensions • • • • Dimensions: 88mm wide, 95mm tall, 470mm long (3.375 x 3.75 x 18.5in) Weight: 1.94kg (4.28lbs) Shipping Dimensions: 102mm wide, 108mm tall, 508mm long (4.0 x 4.25 x 20in) Shipping Weight: 2.15kg (4.
PAGE 4
MNCDL INSTRUCTIONS CONTINUED Setup The circuit board has 3 jumpers to set and a terminal block for 3 wires to connect. The wires are Ground, Battery negative and Battery positive. Using the proper breaker is extremely important as the resistor could over heat and cause fire if the proper breaker is NOT used. We recommend a (MNEPV30) 30 amp breaker for 12 volt battery, a (MNEPV15) 15 amp breaker for a 24 volt battery and a (MNEPV8) 8 amp breaker for a 48 volt battery.
PAGE 5
MNCDL INSTRUCTIONS CONTINUED NOTE: To run the equalize cycle on the inverter or other charge controllers, simply turn off the breaker on the diversion controller and run your EQ charge. After the EQ charge is complete do NOT forget to turn the breaker back on.
PAGE 6
MNCDL INSTRUCTIONS CONTINUED 6|Page 10-342-1 REV: B
PAGE 7
MNCDL INSTRUCTIONS CONTINUED MIDNITE SOLAR INC. LIMITED WARRANTY MIDNITE SOLAR INC. LIMITED WARRANTY MidNite Solar Power electronics, sheet metal enclosures and accessories MidNite Solar Inc. warrants to the original customer that its products shall be free from defects in materials and workmanship. This warranty will be valid for a period of five (5) years for all products except the MNBRAT Charge Controller, MNBIRDHOUSE1 batteries, and MNChinook turbines. These will be two (2) years.