Manual

2 | Page 10- 342- 1 REV: B
MNCDL
INSTRUCTIONS CONTINUED
CHINOOK DIVERSION LOAD
SPECIFICATIONS- 300 WATT MODELS
Operation
• PWM (Pulse Width Modulation) for highest charging
performance without flicker
• Three Stage Charging
• Selectable for sealed or flooded batteries using jumper
• Status and fault indicator LEDs
• Connects directly to the battery bank
12V Version MNCDL300-12
• Operating voltage range: up to 15VDC
• Recommended fuse or circuit breaker: 30 Amps
• Integrated Load Resistor: 0.75 Ohm, 300 Watt, wire wound
24V Version MNCDL300-24
• Operating voltage range: up to 30VDC
• Recommended fuse or circuit breaker: 15 Amps
• Integrated Load Resistor: 3 Ohms, 300 Watt, wire wound
48V Version MNCDL300-48
• Operating voltage range: up to 60VDC
• Recommended fuse or circuit breaker: 10 Amps
• Integrated Load Resistor: 12 Ohms, 300 Watt, wire wound
Important! The battery jumper comes pre-set from the factory for a specific battery voltage.
The load resistor is specific to this same voltage. Do not change the battery jumper to
a different voltage unless you also install the correct resistor for that battery voltage.
Use the correct clipper for your battery bank.