Installation manual and specs

MNDC Installation Instructions
Rev: New Page 5 of 7
Battery Positive connections and shunt wiring
Wire exit to inverter
Din Rail mounted breakers
There are three 2” conduit
knock outs for inverter wire
exit. Carefully analyze the
possible wire exit paths to
the inverter. Six different
shunt placement options
have been provided in order
to better accommodate a
wide range of inverter
options. Cables may also
exit the bottom in order to
reach an inverter not
mounted to the left of the
MNDC enclosure.
Note the 6AWG wire
connected to the lower
section of the inverter
battery breaker. This
comes from the output
breaker from a charge
controller.
The inverter negative
shunt connection has the
corresponding negative
circuit from the charge
controller and negative
from the DC-GFP.
Din Rail mount breakers
shown are for a solar charge
controller and a DC-GFP.
PV in is entering the MNDC
from the bottom in this photo.