Installation manual and specs

MNDC Installation Instructions
Rev: New Page 6 of 7
DC Breakers and Cover
MNDC uses for various different inverter installations.
Remove the DC
breaker cover to install
din rail mount
breakers. Insure the
yellow tab snaps into
place to secure the
breakers. Strip wires
3/8” and bend at ¾”
from end. This section
is very tight so pay
close attention to wire
routing. Use cable ties
to secure wires in a
neatly routed bundle.
Lat the cover plate on
a flat scrap wood
surface and using a
flat screw driver blade
and hammer, cut the
tabs.