MidNite Solar Kid Manual

The KID Solar Charge Controller Instructions
AUX/ WBJr Terminal Block.
To insert a wire:
Strip 5/6" (8mm) and press into the
terminal block until it is seated. Gently
tug to ensure the wire is fully installed.
To remove the wire:
Gently press down on the white plastic next
to the wire while gently pulling the wire out.
Mounting and Wiring with the wall mount bracket:
+
PV
-
+
-
+
-
LOAD
BATTERY
IMPORTANT!
Input, output, and load negatives must be isolated. They are not internally connected.
Inaccurate current readings and damage may result from improper wiring.
Load Positive is internally connected to Battery Positive. Loads are switched in the negative leg.
Most KIDs come pre-installed in the wall mount bracket. See page 1 2 if you need to install your KID into
the wall mount bracket. Select an indoor mounting location that is dry and protected from the elements. Try
to keep the wires to the panels, battery bank, and loads as short as possible. Dimensioned drawings are
provided in this manual to aid in installation. The KID with mounting bracket may also be used as a drilling
template. High quality wall anchors are recommended for securing The KID to the wall.
Use caution to avoid any pipes or wires that may be running through the walls.
Unit must be installed in a vertical position and spaced 2 inches from the back wall to allow air to
circulate behind the unit
The terminal block in the housing is factory pre-wired to the internal terminal block inside The KID.
Torque field connections to 1 0 in-lbs (1 .1 3 Nm).
1 9 | Page 1 0-268-1 REV T