KID Manual

1 8 | Page
1 0-268-1 REV T
The KID Solar Charge Controller Instructions
Aux input/output wiring:
This 3 position terminal block is the aux input/output. Functions such as Auto Gen Start, Low Battery
Disconnect or the WhizBang Jr are connected here.
As new firmware features are added they will be available at
http://www.midnitesolar.com/firmwareIndex.php
Stacking port
Battery temperature
sensor (BTS) port
Do not allow excess
exposed wire
Sample wiring showing PV, Load, Battery, Whizbang Jr., BTS, and stacking cable.
Wires may exit through either conduit fitting.
One Heyco part # M3200
strain relief is supplied for
the power connections.
Important!
The input and output negative
connections must remain isolated.
Failure to do so will cause inaccurate
current readings and possible damage to
the unit.
Load Positive is internally connected to
Battery Positive. Loads are switched in
the negative leg.
One Heyco part # UB-875
bushing is supplied for
other connections.
AUX +
AUX -
WBJR
Small Terminal Block
The top position is AUX + .
The middle position is AUX - .
See page 39.
The bottom position is where
the purple wire from the WBJr .
is connected (Optional).
See pages 1 9, 38, 41 , 44, 55, 59.