Schneider XW E-Panel Manual

XW E-Panel installation manual
3 | P a g e 10- 1 8 5 - 1 R E V : -
Mounting The XW E-Panel:
The XW inverter should be mounted to the wall prior to installing the E-Panel. Pay attention
to the total height of the system. Refer to the dimensioned drawing below.
Installing the E-Panel to the inverter: To install the E-Panel, remove the door and deadfront.
Attach top and bottom wall mounting brackets to the E-Panel using four M6 x 10mm taptite screws
supplied. The top mounting bracket slides up behind the inverter to space the inverter out the proper
distance from the wall. The top mounting bracket does not screw to the wall, but rather just acts as a
spacer
Top left Top right Bottom left Bottom right
Each mounting bracket is held on using two 6mm x 10mm thread forming screws.
Use a #3 Philips screwdriver for these four screws.
Dimensions of XW E-Panel and inverter
Mounting bracket dimensions.